Strain Gauge Transducer Trainer

Built in Dual DC Power Supply IC Regulated +5V DC, 150mA & 3.5Digit Meter 200mV (Weights in mV)

Strain Sensor:

•  Number of Strain Rosette fixed to plate
• Transducer: Temperature Compensated Strain Gauge
• Type: Cu-Ni foil with polyamide carrier base
• Gauge Resistance: 350 Ohms (Normal)
•  Gauge Length: 6mm
• Gauge Width: 4mm
• Gauge Base: 5mmx 4.3mm
• Gauge Factor: 2:1 (Approx)
• Transducer: Strain gauges mounted on a stainless-steel  Measurement Cantilever Beam
• Configuration: Bridge with 2 Arms as Strain Gauges (Wheatstone Principle)
• Range: Upto 1 Kilogram
• Actual Strain: By Various weights to be placed in a pan fixed with the beam
• Excitation Source: DC Regulated Source
• Tare Adjustment: Zero Adjustment by a Potentiometer
• Readout: 3.5 Digit display to indicate Strain in Kilograms
• Test Points: Test Points are provided at various stages in the circuit to observe waveforms and voltages.
• Strain Sensor Mounted on External Base with Output Carrying out through 9 Pin D Connector.
• Weight Box for Weight Measurement
• Power Requirements: 230V, 50Hz +10%

Resistors, Capacitors, IC AD620, Variable Resistor for Gain and Zero Setting, Bridge Circuit on Board., Differential Amplifier with Feedback, Lead Compensation System, O/P Provided on Test Points for Monitoring & Controlling, are mounted on front panel. Front panel built with high class insulated Printed Circuit Board sheet with well printed circuits and symbols with Instruction manual. Connections are brought out through 2mm Colored Sockets. Patch Cords 2mm. The trainer is housed in ABS Plastic cabinet.